Raised Panel Door Design
Generates the inner panel offset contours from the outer door size, with as many steps and tool directions as you set.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Generates the inner panel offset contours from the outer door size, with as many steps and tool directions as you set.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Offset and Tool Direction: offset (mm) and direction (inward/outward) per step
- Form 2 — Door Sizes: width × height (mm) row by row
How to use it
- Pick Raised Panel Door Design from the palette.
- Enter the offset steps and tool directions, OK.
- Enter the door size list, OK.
- Report: number of doors and offset lines produced.
Result
Per door: outer rectangle + ordered inward offset contours; start points and directions set.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros Tools
Other tools in the same package
- Bead Door Design
- Slat Door Design
- Louvre Door Design
- Panel Door Design
- Reverse Direction
- Centre & Align Objects
Try it first
Request a free trial to run the tools on your own drawing.