Louvre Door Design
Draws a series of louvre doors from edge margin, bottom/middle rails and Z bottom/top values.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Draws a series of louvre doors from edge margin, bottom/middle rails and Z bottom/top values.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Louvre parameters: edge margin (mm), bottom rail (mm), middle rail (mm), Z bottom (mm), Z top (mm)
- Form 2 — Door Sizes: width × height (mm) row by row
How to use it
- Pick Louvre Door Design from the palette.
- Enter the louvre parameters, OK.
- Enter the door sizes, OK.
- Report: number of doors and louvres produced.
Result
Door contour and louvre slats; Z bottom/top values are applied to the lines for 3D machining depth.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros Tools
Other tools in the same package
- Bead Door Design
- Raised Panel Door Design
- Slat Door Design
- Panel Door Design
- Reverse Direction
- Centre & Align Objects
Try it first
Request a free trial to run the tools on your own drawing.