Panel Door Design
Draws an interior door leaf from top/bottom/left/right stile-rail sizes and panel layout, then repeats it per the size list.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Draws an interior door leaf from top/bottom/left/right stile-rail sizes and panel layout, then repeats it per the size list.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Door: top rail, bottom rail, left stile, right stile width (mm), first panel height (mm), stile width
- Form 2 — Offset and Tool Direction: panel offset steps
- Form 3 — Door Sizes: width × height (mm) row by row
How to use it
- Pick Panel Door Design from the palette.
- Enter the stile/rail and panel sizes, OK.
- Enter the offset steps, OK.
- Enter the door size list, OK.
- Report: number of doors produced.
Result
Door outer contour, stile/rail lines and panel offsets; doors are laid side by side.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros Tools
Other tools in the same package
- Bead Door Design
- Raised Panel Door Design
- Slat Door Design
- Louvre Door Design
- Reverse Direction
- Centre & Align Objects
Try it first
Request a free trial to run the tools on your own drawing.