3D Wave v4 — Hand-Carved Wood Texture
Puts carving textures such as hand-chiselled notches, gouge marks and wood-grain waves on the door as a 3D surface; 10 models.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Puts carving textures such as hand-chiselled notches, gouge marks and wood-grain waves on the door as a 3D surface; 10 models.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Model: hand-chiselled notches, natural wood-grain ripple, wide gouge marks, fine notch carving, rustic axe / chisel hewing, cross-chisel texture, knot and grain flow, deep gouge flutes, wavy hand-plane marks, hammer-and-chisel texture
- Layout mode: Single Door (the model starts over on each door) or Continuous Flow (one model runs across all doors without a break)
- Z Top (upper level, mm) and Z Bottom (lower level, mm) — carving depth
- Form 2 — Door Sizes: width × height (mm) row by row, up to 20 doors
How to use it
- Pick Hand-Carved Wood Texture from the palette.
- Choose the model from the list; set the layout mode and Z values, Continue.
- Enter the door sizes, Draw and Copy.
- Doors are laid side by side; each gets a 3D model and an outer cutting frame.
Result
A separate 3D surface model (STL) + an outside cutting frame per door; in continuous flow the pattern carries on across doors. 3D roughing/finishing you define with the Alphacam 3D module.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros 3D Wave Panel
Other tools in the same package
- 3D Wave v1 — Fabric / Curtain Drape
- 3D Wave v2 — Sand Dune / Wind Ripple
- 3D Wave v3 — Water Drop / Ripple Rings
- 3D Wave v5 — Acoustic & Geometric Panel
Try it first
Request a free trial to run the tools on your own drawing.