3D Wave v2 — Sand Dune / Wind Ripple
Turns wind lines and dune waves in sand into a 3D door surface; 10 models.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Turns wind lines and dune waves in sand into a 3D door surface; 10 models.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Model: fine desert wind lines, wide dune waves, crossing wind marks, crescent (barchan) dune, beach sand ripple, deep desert dune, stepped wind combing, overlapping wind marks, strong-breeze sand waves, desert hills
- Layout mode: Single Door (the model starts over on each door) or Continuous Flow (one model runs across all doors without a break)
- Z Top (upper level, mm) and Z Bottom (lower level, mm) — carving depth
- Form 2 — Door Sizes: width × height (mm) row by row, up to 20 doors
How to use it
- Pick Sand Dune / Wind Ripple from the palette.
- Choose the model from the list; set the layout mode and Z values, Continue.
- Enter the door sizes, Draw and Copy.
- Doors are laid side by side; each gets a 3D model and an outer cutting frame.
Result
A separate 3D surface model (STL) + an outside cutting frame per door; in continuous flow the pattern carries on across doors. 3D roughing/finishing you define with the Alphacam 3D module.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros 3D Wave Panel
Other tools in the same package
- 3D Wave v1 — Fabric / Curtain Drape
- 3D Wave v3 — Water Drop / Ripple Rings
- 3D Wave v4 — Hand-Carved Wood Texture
- 3D Wave v5 — Acoustic & Geometric Panel
Try it first
Request a free trial to run the tools on your own drawing.