3D Wave v1 — Fabric / Curtain Drape
Places a 3D surface model that looks like folded fabric, flowing lycra/silk or curtain pleats on the door; 10 models.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Places a 3D surface model that looks like folded fabric, flowing lycra/silk or curtain pleats on the door; 10 models.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Form 1 — Model: classic vertical fabric folds, flowing lycra / silk drape, diagonal curtain pleats, asymmetric drapes, soft satin creases, stage curtain, sheer tulle ripple, heavy velvet drape, two-way fabric tension, sculptural organic folds
- Layout mode: Single Door (the model starts over on each door) or Continuous Flow (one model runs across all doors without a break)
- Z Top (upper level, mm) and Z Bottom (lower level, mm) — carving depth
- Form 2 — Door Sizes: width × height (mm) row by row, up to 20 doors
How to use it
- Pick Fabric / Curtain Drape from the palette.
- Choose the model from the list; set the layout mode and Z values, Continue.
- Enter the door sizes, Draw and Copy.
- Doors are laid side by side; each gets a 3D model and an outer cutting frame.
Result
A separate 3D surface model (STL) + an outside cutting frame per door; in continuous flow the pattern carries on across doors. 3D roughing/finishing you define with the Alphacam 3D module.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros 3D Wave Panel
Other tools in the same package
- 3D Wave v2 — Sand Dune / Wind Ripple
- 3D Wave v3 — Water Drop / Ripple Rings
- 3D Wave v4 — Hand-Carved Wood Texture
- 3D Wave v5 — Acoustic & Geometric Panel
Try it first
Request a free trial to run the tools on your own drawing.