Push-Open Hole
Enter the door size; the door is drawn and the push-open mechanism hole is placed at the position you choose.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Enter the door size; the door is drawn and the push-open mechanism hole is placed at the position you choose.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Door width (mm) — 397
- Door height (mm) — 700
- Position (number): 1 top edge centre · 2 bottom edge centre · 3 left edge centre · 4 right edge centre · 5–8 corners (top-left, top-right, bottom-left, bottom-right) · 9 door centre — default 4
- Push-open mechanism hole diameter (mm) — 10
- Distance from edge (mm; from both edges at a corner) — 30
- Door outline: 1 = draw as cutting contour, 0 = reference frame only — 1
How to use it
- Run the macro and enter the door size.
- Choose the position by number (usually the edge opposite the hinges: 3 or 4).
- Enter the diameter and edge distance; you are warned if the hole does not fit.
Result
Door outline on the KESIM layer (or a reference frame on PANEL), a single hole on the DELIK layer.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros Cabinet Door
Other tools in the same package
Try it first
Request a free trial to run the tools on your own drawing.