Handle Holes
Enter the door size; the door is drawn and the handle screw holes are placed symmetrically at the position you choose (edge centre, corner or centre).
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Enter the door size; the door is drawn and the handle screw holes are placed symmetrically at the position you choose (edge centre, corner or centre).
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Door width (mm) — 397
- Door height (mm) — 700
- Position (number): 1 top edge centre · 2 bottom edge centre · 3 left edge centre · 4 right edge centre · 5–8 corners (top-left, top-right, bottom-left, bottom-right) · 9 door centre — default 1
- Handle screw spacing (mm; e.g. 96 / 128 / 160) — 128
- Screw hole diameter (mm) — 5
- Distance from edge (mm; from both edges at a corner) — 40
- Door outline: 1 = draw as cutting contour, 0 = reference frame only — 1
How to use it
- Run the macro and enter the door size.
- Choose the handle position by number (holes run horizontally at edge centres, vertically at corners).
- Enter spacing, diameter and edge distance; you are warned if the holes do not fit on the door.
Result
Door outline on the KESIM layer (or a reference frame on PANEL), two screw holes on the DELIK layer.
Which package includes it?
This tool is part of:
GMacros Cabinet Door Macros
10 macros for kitchen/cabinet doors: door bodies (flat, framed, glazed, louvred), hardware holes and size calculation. Each macro asks a few values and draws on layers.
Product page and price
Other tools in the same package
Try it first
Get a free trial key to run the tools on your own drawing.