Photo Engraving (Halftone)
Turns the photo you pick into geometry to engrave on a panel: V-groove lines that get deeper in dark areas, or a hole pattern that grows with darkness.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Turns the photo you pick into geometry to engrave on a panel: V-groove lines that get deeper in dark areas, or a hole pattern that grows with darkness.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Image file (JPG, PNG or BMP)
- Panel width and length (mm)
- Material thickness (mm)
- Method: V-groove (continuous 3D lines) or stepped hole pattern
- Line / dot spacing (mm)
- Maximum engraving depth (mm)
- V-cutter angle: 90°, 60°, 45° or 120°
- Negative / positive inversion
How to use it
- On the GMacros tab press the GMacros Decor button and pick Photo Engraving from the palette.
- Choose the image file; enter the panel size and material thickness.
- Choose the method, spacing, depth and V-cutter angle; invert the image if needed, then confirm.
Result
With the V-groove method, 3D lines that get deeper in dark areas; with the hole method, circles that grow with darkness (the largest diameter is limited by the V-cutter angle and depth). It does not create toolpaths; machining you define in Alphacam.
Which package includes it?
This tool is part of: GMacros Alphacam Package — GMacros Decor
Other tools in the same package
Try it first
Request a free trial to run the tools on your own drawing.