Hole Array
Draws a regular hole array from column × row counts, spacing and the first hole position; checks the fit when a panel size is given.
The video for this tool has not been recorded yet. What it does is written step by step below.
What does it do?
Draws a regular hole array from column × row counts, spacing and the first hole position; checks the fit when a panel size is given.
Runs on Alphacam Router / Designer; installed with a single .exe.
Values asked
- Panel width (mm; 0 = no frame) — 500
- Panel height (mm) — 720
- Column count (X) — 4
- Row count (Y) — 2
- X spacing (mm) — 32
- Y spacing (mm) — 32
- Hole diameter (mm) — 5
- First hole centre X (mm, from left edge) — 37
- First hole centre Y (mm, from bottom edge) — 37
How to use it
- Run the macro and enter the panel size (0 if you only want the holes).
- Enter the counts, spacing and diameter.
- Enter the first hole's distance from the bottom-left corner; you are warned if the array does not fit.
Result
Columns × rows holes on the DELIK layer; a reference frame on PANEL when a panel size is given.
Which package includes it?
This tool is part of:
GMacros Cabinet Macros
10 macros for carcass parts: sized parts and shelf sets, System 32 and hinge holes, back panel groove, layer, labels and sheet report. Selection-based macros ask for the selection when they run.
Product page and price
Other tools in the same package
Try it first
Get a free trial key to run the tools on your own drawing.